Page 5
For technical questions, please call 1-800-444-3353.
SKU 92626
not specifically designed for it. An
example of an A-frame hitch is shown
in Figure 1.
4. Insert the top of the Trailer Jack up
through the hole in the center of the
A-frame hitch until the mounting plate
rests against the hitch. Line up the
holes on the mounting plate with
the holes in the A-frame hitch. See
Figure 2.
Assembly
1. Raise the Trailer Jack to its
uppermost position. Insert the Foot
Plate (11) over the bottom of the
Inner Tube (2).
2. Insert the Locking Pin (12) to secure
the Foot Plate in place. See Figure 3
below and the assembly diagram on
page 9.
3. Secure the Trailer Jack to the trailer
tongue using 3/8” diameter bolts,
washers, nuts and lock washers (not
included). Nylon insert nuts (not
included) may be used instead of
the nut and lock washer mentioned.
Securely tighten all nuts and bolts
into place. Bolts must be of a length
so that at least 4 threads of the Bolt
tip are exposed below attached Nut.
4.
WARNING!
Bolts must be Grade 5
strength capable of holding the Trailer
Jack in place while under load.
5. Optionally, the mounting plate may be
welded into place on the underside of
the hitch by a certified welder.
6. Once the Jack is mounted to the
trailer tongue, attach the Handle (10)
to the top of the Trailer Jack. Secure
in place with Bolt (7), Lock Nut (8)
and Screw (9). Securely tighten all
hardware.
Figure 1
Example of hitch (not included)
Figure 2
Trailer
Tongue
Figure 3
Locking Pin (12)
Foot Plate (11)
