Haug 04.7614.000, Operating Instructions Manual

Page: 10 / 24

5 Installation
5 Installation
1. Check whether the MJ II
corresponds to the ordering data.
•
In the event of any damage to
the
MJ II , contact
HAUG GmbH & Co. KG.
2. Prepare the installation site with
regard to the following installation
parameters:
ATTENTION!
No ionization is possible at locations
where the ionizing pins are covered by
fixing elements or machine parts. At the
covered points, an arc or leakage path
may form due to contamination of
electrically conductive materials, and
damage the ionizing unit.
•
Never attach mounting elements or
machine parts over the ionizing pins.
The most favourable distance of the MJ II
to the material to be ionized is approx.
20 – 300 mm.
The limit values for the ionizing effect are
at 10 mm min. and 500 mm max.
10