HASE 8160, Owner'S Manual

Page: 9 / 31

HearthStone Quality Home Heating Products, Inc. Luno Model #8160
I
NSTALLATION
H
EARTH
& F
LOOR
P
ROTECTION
R
EQUIREMENT
The Luno may be placed directly on a non-
combustible surface or wood floor. When installing
the Luno on carpet, vinyl, or any other combustible
floor other than wood flooring, it must be installed on
any non-combustible or wood panel extending the full
width and depth of the stove.
C
LEARANCE
T
O
C
OMBUSTIBLES
Due to high surface temperatures, install the unit out
of traffic and away from furniture and draperies. Do
not place clothing and other flammable material on or
near the heater. When positioning the unit always
maintain adequate clearances around air openings
into the combustion chamber and allow for adequate
ventilation. You must maintain minimum clearances
to combustibles as shown in the illustrations of this
section.
Ensure you consider the need for access to the gas
control valve access door on the front of the unit as
well as full access for periodic cleaning and servicing.
CAUTION: THESE CLEARANCES REPRESENT
MINIMUM DISTANCES IN ALL CASES, WHICH,
THROUGH TESTING IN AN INDEPENDENT
LABORATORY TO ANSI AND CSA STANDARDS,
WILL PREVENT FIRE OR SPONTANEOUS
COMBUSTION. WE DO NOT CONTROL THE
COMBUSTIBLE MATERIALS EXPOSED TO HEAT
BY THIS PRODUCT; THEREFORE, AN
ASSESSMENT MUST BE MADE BY THE
INSTALLER TO PREVENT CONSEQUENTIAL
DAMAGE OF WALLS AND FLOORING.
O
PENING THE FRONT DOOR
In order to gain access to the firebox you must open
the front door. The door is held closed with two
machine screws, one on the top above the door, and
one below the lower right corner of the door. To
access these screws you must remove both the top
stone and open the lower control access door located
just below the front door. Do not remove the stone
leveling screw containing the brass lock nut. Use the
provided tool to release the pressure on the screws
before removal. Remove the mounting screw using a
4mm or 5/32” Allen wrench.
Replace these screws
when the door is closed for operation; the door
will not seal without them.
Use the provided tool to
apply pressure on the door seal before installing the
screws (see Figure 2).
Figure 2 – Door Assist Tool
I
NSTALLING THE
D
ECORATIVE
T
OP
S
TONE
Remove the top stone from the packaging carefully.
Despite the mass of the piece of soapstone, it will
break if dropped. Locate the hole drilled in the bottom
of the stone. This hole will determine the bottom and
front of the stone. Place the stone on the platform
above the door accordingly. Adjust the stone so it has
an even gap all around the back against the stove
wall.
6