®
94731/94729 Asst.
PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
x3
BATTERIES
ALKALINE
REQUIRED
1.5V AAA or LR03 size
Phillips/cross head screwdriver (not included)
needed to insert batteries.
NOT INCLUDED
D A R T H V A D E R
™
L I G H T S A B E R
™
F O R C E F X
w i t h R e m o v a b l e B l a d e
C O L L E C T I B L E
Adult Collectible
Some assembly required.
Never use to strike people or animals.
P/N 7041360000
WARNING!
To prevent risk of electric shock or serious injury, never
disassemble the lightsaber blade.
•
DO NOT attempt to perform any repairs yourself.
There are no consumer
repairable parts inside.
•
Never use to strike others.
This product is not intended for striking people,
animals or objects. This product is not covered by warranty for damage
caused by striking against hard objects.
• Never run with the lightsaber. Never use the lightsaber in total darkness.
• Always check the area around you before swinging the lightsaber to ensure
you do not injure anyone or cause damage.
• Turn off the lightsaber when not in use. Never leave the lightsaber on when
unattended.
• To prevent risk of electric shock or serious injury, never immerse the
lightsaber in water or allow the lightsaber to become wet. Use only a soft, dry
cloth to clean.
• If the blade of the lightsaber becomes cracked or damaged, stop using the
lightsaber immediately.
BATTERY INSTALLATION & ASSEMBLY
1. Make sure the lightsaber is OFF.
2. Unscrew pommel (end cap)
counter-clockwise to expose
the battery pack.
3. Completely remove the battery pack
from the hilt (handle).
4. Using a Phillips/crosshead screwdriver (not included), loosen screw in
battery pack sleeve (screw will remain attached to sleeve). Slide sleeve off
battery pack.
5. Insert 3 x 1.5V “AAA” or LR03 size
alkaline batteries in the battery pack.
Make sure the batteries are correctly
oriented; refer to the + and – markings
as a guide.
6. To re-insert the battery pack, slide sleeve back onto pack,
and tighten screw. Align the yellow arrow on the pack
with the yellow triangle inside the hilt (handle).
Slide it in until it stops.
DO NOT FORCE!
7. Replace pommel (end cap) by screwing
it on clockwise.
Product and colors may vary.
© 2010 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.
®* and/or ™* & © 2009 Hasbro. All Rights Reserved.
TM & ® denote U.S. trademarks.
IMPORTANT:
BATTERY INFORMATION
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
CAUTION:
1. As with all small batteries, the batteries used with this product should be
kept away from small children who still put things in their mouths. If they
are swallowed, promptly see a doctor and have the doctor phone (202)
625-3333 collect. If you reside outside the United States, have the doctor
call your local poison control center.
2. Always follow the instructions carefully. Use only batteries specified and be
sure to insert them correctly by matching the + and – polarity markings.
3. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
4. Remove exhausted or dead batteries from the product.
5. Remove batteries if product is not to be played with for a long time.
6. Do not short-circuit the supply terminals.
7. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and back on
again or removing and re-inserting batteries) if necessary.
8. RECHARGEABLE BATTERIES: Do not mix these with any other types
of batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
2
3
4
5
6
7
1
BATTERY INSTALLATION & ASSEMBLY
(Continued)
Y
K
Customer Code: 5008/94731_94729_SW_vader lightsaber.indd
2010-01-0242/Sunday/2010-01-19/EP1_CT-Coated
