4
Setup Instructions
1. Turn the control system on. After a few seconds the Main Menu screen should appear. Press Setup
Mode, the Setup Mode screen will then appear.
2. Press Yield Mapping setup.
a. Yield Mapping Setup will now be displayed.
3. Press the underlined value next to
Swath Width (Ft).
Enter in the swath width that will be baled, press
Enter
to confirm.
4. Enter the underlined value next to
GPS.
Enabling the GPS will require entering the appropriate value.
Press 0 to Disable, 2 to Enable the Garmin GPS. Press
Enter
to confirm.
Operation Instructions
1. Once installation and setup is complete the system is ready for baling. There is a GPS indicator icon
that will appear in either of the Automatic or Manual mode screens. The GPS icon shows the user that
the GPS is transmitting data to the DCP to be processed. The GPS icon, if getting a good satellite
signal, will continually increase/decrease in size. While all this is going on a Yield file is being created
and saved to the DCP.
2.
Once baling is complete, create a
New Job
and the yield data file that was written to the DCP yield file
will be complete and ready to be converted. See
CONVERTING YIELD DATA FILE
for the next step.
*NOTE
: If you’re a first time user, begin with the
INSTALLATION OF YIELD DATA FILE CONVERTER
PROGRAM
before attempting to convert the yield data file.
*There is no indication the system is connected to a GPS when using and ISO monitor or an iPad.
2
GPS
ICON
3
4