3
Installation of Dye Sprayer Tank & Plumbing
Installation of Mounting Bracket & Tank
– CASE & New Holland Large Squares
Locate the tank and mounting bracket assembly. Looking at Figure 1 decide where a desirable mounting
location will be the most convenient and work the best for the user.
a. Once tank location is decided, mark the mounting holes and drill
out using 3/8” bit.
b.
Fasten the mounting bracket to the baler using the 5/16” hardware provided in the kit.
System Wiring
Setting up Tractor
1. Connect the red and black eye-loop connectors from 006-765IC Tractor Power/Communication harness
DIRECT
to tractor battery. Route 18 pin plug to drawbar of tractor and the other leg of the harness with the 12
Pin and 4 Pin connector into the cab of the tractor.
2. 006-6673 ISO Communication Module (ICM) mounts in the cab of the tractor and connect 006-765IC 12 pin
header harness to it.
3. Connect 006-765CPH key power harness to 4 pin plug on 006-765IC harness near ICM. Securely fasten to
key power outlet in cab of tractor
4. Secure wires with zip ties.
Setting up baler
.
1. Route 006-765BN harness from draw bar of baler back toward Balers ECU
2. Remove 006-7303CMS star wheel harness plug from Baler ECU CAN 2 connection and attach 006-765BN
to same connection of 006-7303CMS harness.
3. Remove 006-4640J resistor plug from the 006-7303CMS harness and attach 006-
765VN to same connection of 006-7303CMS. Reattach 006-4640J to port on 006-765VN.
4. Locate the CAN Port 1 on the baler ECU. Remove 6 pin active terminator (X504) from
CAN 1 (Figure 2) and attach active terminator to 006-765VN harness 6 pin plug
5. Attach 006-765VN harness to Baler ECU CAN 1 plug
Setting up Dye Marker
1. Locate the wiring harness (006-765IDM3) supplied in the 239 dye Sprayer Marking Kit.
Connect to triangle plug on the metal frame of the dye marker.
2. Route Dye Marking harness (006-765IDM3) to main star wheel harness (006-7303CMS) and attach it to
triangle CAN plug found near star wheels. Secure with zip ties
Figure 1
Common New Holland and CASE IH baler
mounting position
Figure 2
