Propeller Owner’s Manual
139
INSTALLATION AND REMOVAL
61-00-39
Page 3-18
Rev. 17 Apr/20
(11) If the propeller is equipped with an ice protection
system that uses components supplied by Hartzell
Propeller Inc., refer to
Hartzell Propeller Inc. Propeller
Ice Protection System Manual 180 (30-61-80) for
applicable instructions and technical information.
(12) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder’s Instructions for Continued
Airworthiness (ICA).
C. Installing HC-B(3,4,5)( )(A,N,P)-3( ) Propeller on the Aircraft
Engine
CAUTION:
INSTRUCTIONS AND PROCEDURES IN
THIS SECTION MAY INVOLVE CRITICAL
PARTS. REFER TO THE INTRODUCTION
CHAPTER OF THIS MANUAL FOR
INFORMATION ABOUT PROPELLER
CRITICAL PARTS. REFER TO THE
ILLUSTRATED PARTS LIST CHAPTER OF
THE APPLICABLE OVERHAUL MANUAL(S)
FOR THE IDENTIFICATION OF SPECIFIC
PROPELLER CRITICAL PARTS.
NOTE: The use of a fretting disk between the propeller
flange and engine flange is recommended on
certain applications for propeller models
HC-B5MP-3( ). Refer to Hartzell Propeller Inc.
Service Bulletin HC-SB-61-275 information about
affected applications.
(1) Use a beta system puller CST-2987 (Figure 3-5) to
compress the beta system and pull the beta ring forward
to allow installation of the double hex head propeller
mounting bolts.
