INSTALLATION AND REMOVAL
61-00-75
Propeller Owner’s Manual
175
Page 3-51
Rev. 1 Jun/11
H. Installing F Flange Propeller Models HC-83(X,V)F-3( )( )
Refer to Figure 3-11.
(1) Install the beta valve inside the engine shaft. Refer to the
engine manufacturer’s instructions.
WARNING
:
CLEANING AGENT MEK IS FLAMMABLE
AND TOXIC TO THE SKIN, EYES AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT. USE IN A WELL
VENTILATED AREA.
(2) Clean the engine flange and propeller flange with Quick
Dry Stoddard Solvent or MEK.
(3) Lubricate the specified O-ring with engine oil and install
it on the engine flange. Refer to Table 3-1.
WARNING
:
MAKE SURE THE SLING IS RATED UP TO
800 POUNDS (363 KG) TO SUPPORT THE
WEIGHT OF THE PROPELLER ASSEMBLY
DURING INSTALLATION.
CAUTION
:
WHEN INSTALLING THE PROPELLER
ON THE AIRCRAFT, DO NOT DAMAGE
THE ICE PROTECTION SYSTEM
COMPONENTS, IF APPLICABLE.
(4) With a suitable crane hoist and sling, carefully move
the propeller assembly to the aircraft engine mounting
flange.
(5) Align the mounting and dowel pin holes in the engine
flange with the mounting holes and dowel pins in the
propeller hub flange.
OBSOLETE PROPELLER MODELS. SEE COVER PAGE
WARNINGS AND SERVICE BULLETIN HC-SB-61-331
