Propeller Owner's Manual
136
INSTALLATION AND REMOVAL
61-00-36
Page 3-14
Rev. 2 Feb/17
B. Installation of a Metal Spinner Bulkhead on a Propeller Hub
CAUTION:
INSTRUCTIONS AND PROCEDURES
IN THIS SECTION MAY INVOLVE
PROPELLER CRITICAL PARTS. REFER
TO THE INTRODUCTION CHAPTER
OF THIS MANUAL FOR INFORMATION
ABOUT PROPELLER CRITICAL PARTS.
REFER TO THE ILLUSTRATED PARTS
LIST CHAPTER OF THE APPLICABLE
OVERHAUL MANUAL FOR THE
IDENTIFICATION OF SPECIFIC
PROPELLER CRITICAL PARTS.
(1) Spinner installation must make sure of clearance in the
following areas:
(a) The spinner bulkhead must be spaced between the
hub and the engine cowl to permit the spinner dome
blade cut-out openings to clear the propeller blades
at all blade angle locations. Refer to Figure 3-4.
1
The spinner bulkhead and any attached filler
plate must also clear the propeller blades at all
blade angle locations. Refer to Figure 3-4.
(b) The edge of the spinner bulkhead and the installed
spinner dome that faces the engine cowl must
have space to clear the engine cowl and avoid
interference during propeller/engine operation.
Refer to Figure 3-4.
(c) The hub clamping bolts on which the spinner
bulkhead is attached must not be so long that the
bolts interfere with the engine cowl during
propeller/engine operation. Refer to Figure 3-4.
1 On some installations, it may be necessary to
install spacer(s)/washer(s) between the head of
each hub clamping bolt and the hub to move the
threaded end of the bolt away from the engine
cowl. Refer to Figure 3-4.
