Propeller Owner's Manual
136
INSTALLATION AND REMOVAL
61-00-36
Page 3-11
Rev. 2 Feb/17
3. Spinner Pre-Installation
A. General
(1) The spinner support must be attached before the
propeller can be installed. The spinner dome will attach
either to a spinner bulkhead attached to the propeller
hub, or, on some Lycoming engine installations, to an
adapter ring unit attached to the engine starter ring gear.
Follow the applicable directions in this section.
(2) Refer to Figure 3-2. Remove the nuts from the hub
clamping bolts that are located on either side of the
blade shank.
(a) Do not loosen or remove the remaining nuts
and bolts.
(3) Refer to Figure 3-2. The spinner may be supplied with
long hub clamping bolts. If the bolts were supplied with
the spinner, remove the bolts on either side of the blade
shank and replace them with the bolts supplied with the
spinner. The supplied hub clamping bolts will be longer
than those removed from the hub.
NOTE: Depending upon the installation, the propeller
hub may have been shipped from the factory
with the longer hub clamping bolts already
installed. In this case, the hub clamping bolts
will not be supplied with the spinner.
