HM-USB-ISO User Manual
MAN-1008 19/7/2012 v2
Designed and Produced under
Page 2 of 8
ISO 9001:2008 Certification
Installation
Step 1) Install Software Drivers
Before using the USB HART Modem a USB Virtual Serial Port Driver must be installed on the Windows
PC/Laptop/Tablet, one is supplied on the enclosed CD. Alternatively, it can be downloaded using
http://www.hart-expert.co.uk/wp-
content/uploads/USB_HART_Modem_Virtual_Serial_Port_Driver.zip
If using the CD insert it into your MS Windows PC and then the USB Virtual Serial Port driver will install
automatically
if “AutoPlay” is enabled on your PC
. If
it doesn’t install automatically
open/run
“setup.exe” on the CD
.
If using the CD, after the USB Virtual Serial Port driver has completed installation the program “HM Test”
will open ready for you to latter test your USB HART Modem connection. If you are not using the CD, HM
Test can be downloaded from
http://www.hart-expert.co.uk/wp-
content/uploads/HART_Modem_Test_Windows.zip
, but for now continue to Step 2.
Step 2) Connect the USB HART Modem to your PC
Once the driver is installed, you can connect the USB HART Modem to a USB port on your PC. See the
relevant section below based on your PC’s operating system.
a)
Windows XP
After the USB HART Modem is connected and the New Hardware Found wizard is finished, the following
will appear at the bottom of the screen:
Note: A completion message may not appear on some systems.
b)
Windows Vista and Windows 7
After the USB HART Modem is connected and the New Hardware Found wizard is finished, the following
will appear at the bottom of the screen:
Note: A completion message may not appear on some system.
