RUG-005/006/018/019/051
No.1 Steel Rugby Posts
INS618
Revision 5
09/09/2015
Harrod UK Limited
©
Important note for RUG-045/046/055
If you have purchased RUG-045, RUG-046
or RUG-055 then please install to instruction
number INS617 supplied with the uprights.
Code:
Product:
No.1 Steel Rugby Posts
RUG-051 Hinge assembly only
1. 4 x FEP208
Hinge Assembly
2. 4 x FEQ651
Bottom Upright
1. 4 x FEP208
Hinge Assembly
(RUG-018/019)
(RUG-005/006)
(RUG-018/005)
2. 4 x FEQ656
Bottom Upright
3. 4 x FEQ652
Top Upright
3. 4 x FEQ655
Top Upright
4. 2 x FEQ650
Crossbar
5. 4 x RUG-109 Ground Socket
(RUG-018/019)
(RUG-019/006)
IMPORTANT
PLEASE READ THE ASSEMBLY
I N S T R U C T I O N S C A R E F U L LY B E F O R E
STARTING TO ASSEMBLE YOUR POSTS.
IMPORTANT
Assembly of these posts
should not take place in windy conditions.
For safety reasons; Post Protectors must be
used with all Hinged Rugby Posts to cover
the hinge arrangement.
Pack Contents:
4
5
2
1
3
View of Product
Fig 1
1220
1220
1220
Tools Required
1 x 24mm Spanner
2 x 19mm Spanners
1 x 17mm Spanner
1 x Spirit Level
1 x Tape Measure
2 x Step Ladders
Safety Notes
1
2
4
A risk assessment must be carried out on the
erection of Hinged Rugby and Rugby Adaptors.
Always use mechanical assistance if the Risk
Assessment highlights this requirement.
Always check fasteners before use and tighten
where necessary.
Periodically apply grease to hinge fixing bolts to
pre-long the life the posts.
Posts should always be taken down if strong
winds are forecast.
3
5
Supplied with
RUG-018/019 &
051 only
Important Note for RUG-051
If RUG-051 has been purchased for
adapting an existing set of rugby posts, you
will need to cut down your existing uprights
as follows:
For sockets installed 25mm below ground
level the distance from the underside of the
channel to the bottom of the upright needs to
be 2899mm. For sockets flush with ground
level this needs to be 2874mm.
