4 – Front Panel Configuration & Operation
HD Link Installation & Operation Manual
Version 2, April 2010
Harris Corporation
4-39
Intraplex Products
Output Power
Select
Output Power
on the
RF Profile
front panel screen to access the
Output Power
configuration screen (Figure 4-62) and set the wattage of transmitter output power.
Figure 4-62. RF Profile
Output Power
Press these buttons on the display to configure the bandwidth in watts:
•
Press
to change the output power value.
•
Press Enter to keep changes until you can
Apply
them on the previous screen.
•
Press Cancel to erase your changes and return to the previous value.
You can set
Output Power
to
1W
,
2W
, or
5W
.
Color Codes: White = currently applied value; yellow = value changed but not saved or applied.
Cancel: Press this button to return to the previous screen.
Note:
If you make any changes to this screen, you must select
Apply
and press Enter on the
previous screen to save and apply changes.
4.1.6.2 Radio Parameter Status
Select
Radio Parameter Status
on the
Service Setup
screen to access the
Radio Parameter
Status
screen (Figure 4-63).
Figure 4-63. Service Setup
Radio Parameter Status
Modulation:
Current radio modulation rate.
Coding Rate:
Current channel coding rate.
You cannot make any changes to the parameter status on this screen.
Back:
Select this command and press Enter to return to the previous screen.
Color Codes: White = currently applied value.