Harris Corporation
Constellation™
Installation and Commissioning
4-25
INSTALLATION AND
CO
MM
ISSIO
N
IN
G
Figure 4-16: Transmitter Assembly, front view
7.
Measure the REF MON frequency of the Receiver Assembly
a. Record the operating frequency of the Receiver from the Keypad
(hidden menu).
CONFIGURATION > F1 + F3 or Ctrl B > RX FREQ
b. This frequency should match the one written on the Rx filter and the
station authorization.
c. Determine from the table in
which multiplier-filter should
be used (or is in use).
Note
: To prevent damage to
the connectors, do not
exceed 8 to 9 in-pounds of
torque.
IF IN (from Modem)
RF OUT (to ACU)
Thumb screw (2)
Transmitter
output level
LO MON
LO synthesizer test
point
(2.060 to 2.160 GHz)
(
For factory use only
)
REF MON
Reference frequency
test point
(100 MHz)
ON/OFF switch, turns the
power amplifier on or off
FAULT (red LED)
ON LINE (green LED)
TSL
GND
Handle
Caution
: When measuring
Tx power at RF OUT, over
torquing may cause damage.
For on-line Tx, use monitor
port at front of ACU.
Refer to product
documentation.
Summary of Contents for Constellation
