16
Control Panels for X75 Systems Installation and Operation Manual
Chapter 2: Operation via Front Panel Controls
Video Input
With control panel video shortcuts, you can select an input (or multiple
inputs) and immediately send it to all video outputs by pressing the
Video In
button. The LEDs on the left side of this button indicate which
input is currently selected.
To change the input signal type, follow these steps:
1. Press
Video In
on the control panel, (or navigate to the
Routing
Setup
menu and select
AllOutSelect
).
All available inputs will display on the control panel screen.
2. Use the control panel knob to scroll through the list of input types,
and then press to
Enter
to select one.
The associated video input LED will become lit. In an example
where the
SDI 1
LED is lit, the routing is set automatically such
that the SDI input signal is upconverted and sent to the HD-SDI
output, and to all SDI/Analog outputs.
Figure 2-4.
Video Input Control Area
1. Press
Video In
2. The LED for the
corresponding
video input type
lights up
The Video
LED lights
during input
selection
Summary of Contents for assuredcommunications X75-RCP
