TV 40
TV 40
12
13
Stopping Operation
1.
Move the flap lever to the open
position.
2.
Close the hose door.
3.
Store hose in cavity between hopper
and frame.
Flap Adjustment
•
If there is not adequate suction at the
hose make sure the flap is closing
completely (a small gap will work be-
cause the vacuum will suck it shut). If
there is a big gap, the flap may need
adjusted. Loosening the adjustment
nut will shorten the flap lever causing
the flap to close tighter.
Edge Brush Option (900216)
•
Follow instructions in Parts Section for
installation of Edge Brush Option.
•
The edge brush kit is used for cleaning
areas along fences and curbs, etc.,
that are difficult to reach with the Turbo
Vac broom.
•
The edge brush can be adjusted verti-
cally and horizontally, as well as
rotated at an angle, so that debris
is thrown into the Turbo Vac broom.
For best results, angle the front edge
of the brush downward.
•
The stop chain is used to adjust the
height of the brush during operation
and to hold it up during transport.
•
Never allow the brush to rest com -
pletely on the ground during operation.
SAFETY WARNING!
The Turbo Vac should never be
transported with the edge brush in
operating position. Always use the stop
chain to suspend the brush during
transport.
Contact your Harper Dealer for more infor-
mation about optional equipment, or see
the Harper Industries website at:
www.harperindustries.com
SAFETY WARNING!
•
Before servicing or inspecting the
Turbo Vac, make sure the power
source is shut off and all moving
parts have stopped.
•
Always wear safety glasses and
protective gloves when servicing
the Turbo Vac.
Blower Liner
IMPORTANT!
Regularly check the BLOWER LINER in
the blower housing for wear. Failure to
maintain blower liner may result in
damage to the blower housing.
To check Blower Liner:
Remove access panel.
Check white plastic liner located around the
inside walls of the blower housing around the
blower fan.
If liner is damaged or worn through; replace
to avoid damage to blower housing.
Part # 972009 or 972021 for a heavy duty
urethane liner.
NOTE
: Blower liner is a wear item and is not
covered under warranty. Sandy conditions
may shorten the life of the blower liner.
Screens
Periodically check the return air screens
located in the hopper for excess buildup.
Excess buildup can reduce performance and
or negate the return air system causing an
increase of dust.
To Clean Main Screen:
Remove the two
pins holding it in place. The screen will then
swing down and can easily be cleaned out.
Service & Maintenance