Harper Turbo vac 30, Operators Manual And Parts Lists

Page: 14 / 93

TV 30
R
Cooling System
• Clear hydraulic oil cooler and radiator
of debris with pressurized air daily or
as needed.
• Remove screen on side of oil cooler
to clean properly. It is released by
pulling the tabs located on top and bot-
tom of the screen.
• Remove vent in front of radiator if
needed to clean.
• Check radiator level daily and only
when engine is cool and not running.
• Remove cap (radiator fill) slowly to
relieve any pressure that may be built
up.
• Fill up radiator with coolant (50% wa-
ter/ 50% antifreeze) until coolant is vis-
ible in neck of radiator.
• Make sure that the coolant recovery
bottle has at least 1” of coolant in bot-
tom. The presence of coolant in the
revocery bottle does not mean radiator
is full.
SAFETY WARNING
Hot Coolant and steam from the radiator
can cause severe burns. Never open the
radiator cap of a hot engine.
Engine Oil
• The dipstick and engine oil fill are lo-
cated on the back left side of the en-
gine.
• The engine oil filter is located at the
back of the engine and it is obtainable
from the bottom.
• To get to the engine oil fill or dipstick,
the cover must first be taken off by
removing the two wing bold on the top
of the cover (see image on previous
page spread) .
PROCEDURE
• Check engine oil level only when en-
gine is turned off.
• Keep engine oil level between the
FULL and ADD marks on dipstick at all
times. DO NOT OVER-FILL.
• Add engine oil (S.A.E. 10W30) through
the engine oil fill location.
• Replace the engine oil according to
the Maintenance Schedule.
• Replace the engine oil filter according
to the Maintenance Schedule.
SAFETY WARNING
Keep dipstick and oil fill cap secured
tightly. Engine oil may escape through
these orifices when engine is running
causing severe burns.
Coolant Recovery
Bottle
Radiator
Hydraulic
Oil
Cooler
Radiator Fill
Engine Oil Filter
Engine Oil Fill
Dipstick
12