InstallatIon and operatIon Manual for WInd and sun screen sl400
09/12
|
8
always make sure that the supporting system is mounted perfectly vertically and is correctly
anchored. the height of the pull rod depends on the height of the screen. for the locking
system the rule of thumb is to have it positioned at half the height.
4.10. optional installation of a supporting system for wall or railing assembly (a2639)
Instead of mounting the supporting system directly
with wall or railing mounted systems, it can also be
mounted to the wall using a wall console for columns
(option a2639). In this case the wall mounting block
must be removed, so the supporting system can
be secured to the wall console with the three bolts
supplied. depending on the mounting surface, the
fitter must choose a particular option for securing
the console to the wall.
the mounting height of the wall console needs to
be such that the top of the cover & lock plate of the
supporting system are at the same height as the bottom
of the handgrip of the pull rod. correct alignment of
the wall console is also very important here.
4.11. fine-tuning of the handgrip height and the supporting system
If the bottom of the handgrip of the pull rod does not grip into the cover & lock plate, then
this can be resolved by lowering or raising the handgrip. this is done by gently unscrewing
two countersunk screws, repositioning the handgrip and then tightening the screws again.
(A2641)
(A2640)
Floor assembly
(A2642)
Wall assembly
(A2644)
Railing assembly
(A2643)
