Harmony Hi Lo Tilt HS, Assembly And Operation Manual

Page: 15 / 28

1
3
Scenario 2: Installing Headboard
Raise the Backrest by using Remote Control (A) and remove the Head Rail.
Take out the Wrench (J), two Bolts (K), two Washers (M) and two Nuts (L) from the accessories box.
Refer to the following picture. Place the Headboard Bracket (H-2) on the tube of the right hand side of
your Adjustable Base. Insert the Bolt (K) with its Washer (M) through the pre-drilled holes on the
Bracket (H-2) and the tube.
Fasten the two Bolts (K) with the two Washers (M) and the two Nuts (L) with the two Washers (M) by
using the Wrench (J).
Redo this step on the left hand side of your Adjustable Base.
The Bracket (H-
1) allows adjustment to meet the dimension of user’s Headboard (not
included). After
choosing desired pre-drilled holes on the H-1 Bracket, pass the Bolts (K) with the Washers (M) through
the holes on H
-
1 and H
-
2 Brackets. Fasten these Bolts (K), Washers (M) and Nuts (L) by using the
Wrench (J).
Step 1
5
Now place your mattress on your Adjustable Base.
All the installation procedures have been completed.