USING HIGH CHAIR
!
ENSURE
that
BOTH
the Chair and Table are properly assembled and all Plastic Screw Caps are secured tightly
before using in high chair mode.
1. Insert the legs of the chair into the corresponding holes of tabletop ❶. The chair
ONLY
fits into the table one
way.
DO NOT
force the chair legs into the holes. If the legs do not fit into the tabletop, turn chair around. Once
the legs are inserted into the tabletop, push down firmly to ensure the chair is fully inserted in the table.
! WARNING
:
ENSURE THE CHAIR IS FULLY INSERTED INTO THE TABLE CORRECTLY BEFORE PLACING YOUR CHILD
IN THE HIGH CHAIR
.
! WARNING
: Prevent serious injury or death from falls or sliding out by
ALWAYS
using the tray along with the
harness system in high chair mode.
! WARNING
: The child
MUST
be secured in the high chair at all times by the harness system. The tray is
NOT
designed to hold the child in the chair.
❶
INSERTING/REMOVING TRAY
The Main Tray (part N) has three (3) positions ❶.
1. Squeeze the adjustment tabs on each side of the (underside) of the Main Tray ❷ while sliding the Main Tray into
the guides on the top of the chair sides ❶.
TIP
: Place your foot on the Table Crossbar (part L) to make adjusting tray easier.
! WARNING
: Wash both Main Tray and Removeable Insert Tray thoroughly before first use and after every meal.
❶
❷
RECLINE
! WARNING
:
NEVER RECLINE CHAIR WITH CHILD SEATED IN THE CHAIR
.
! WARNING
: It is recommended that the high chair be used in the upright position only by children capable of
sitting upright unassisted.
There is one (1) upright position and two (2) reclined backrest positions on this chair ❶.
Adjust the backrest recline angle by squeezing the Recline Handle (part P) on the rear of the backrest ❷. Move
the backrest to the desired position and release the handle to lock it into place.
ENSURE
the backrest is locked into
the desired position by gently pushing / pulling on it.
!
ENSURE
that the seat is locked into position before placing child in high chair.
❶
❷
ENSURE
that
BOTH
the Chair and Table are properly assembled and all Plastic Screw Caps are secured tightly before using in activity center
mode.
To convert high chair into activity center, simply lift the Chair up and out of Table Top ❶.
TIP
: Place your foot on the Table Crossbar (part L) to make lifting the chair easier.
Chair should be set in the upright position (See “Recline”, pg. 6) when using as an activity
center.
Insert the four (x4) Tabletop Caps (part Q) into the openings in the tabletop to prevent
items from falling through ❷. There are two (x2) larger back and two (x2) smaller front
Tabletop Caps. These can be removed and re-inserted as needed when converting modes.
The chair can also be used as a low-sitting feeding table when used with the tray ❸.
! WARNING
: Chair should
ONLY
be used on the ground when not being used as part of the
high chair mode.
!
DO NOT
use chair or table on uneven surfaces.
!
NEVER
carry or move the chair with child in it.
❶
❷
❸
USING ACTIVITY CENTER
6
