Chapter 2: Spectrum system installation
Installing the bezel
The bezel ships separately from the MediaStore. Install the bezel before connecting to your system.
Before you begin
Make sure the MediaStore is mounted on the rack and the drives are installed prior to installing the bezel.
1. Connect the cable inside the bezel to the 4-pin connector on the right side of the front panel.
2. Fit the two posts on the right side of the bezel into the holes in the rack ear on the right side of the
chassis.
The bezel cable should form a loop that fits inside the metal panel of the bezel.
3. Press in the release button on the left side of the bezel while pushing the left side of the bezel straight
onto the chassis, and then release the button.
The posts on the left side of the bezel will fit into the holes in the rack ear and secure the bezel on the
chassis.
Result:
IMPORTANT:
For optimum airflow, do not obstruct the air vents on the bezel.
Figure 2-14: Installing the bezel on the MediaStore 7200
Connecting the MediaCenter to the MediaStore 7200
You can connect the MediaCenter to the MediaStore 7200 via SAS for additional storage.
The MediaCenter 2200B provides one SAS connector.
The MediaCenter 2200B-DS provides two SAS connectors.
42
