MediaStore 5100 and 5000 series rear panel
NOTE:
The MediaDirector 2252B/2251B requires a different SAS cable than previous
MediaDirector models. To make sure you have the correct SAS cable, contact your
Harmonic sales representative.
MediaStore5100: I/O module status LEDs
The I/O modules include status LEDs for help with troubleshooting.
Figure 9-8: I/O module status LEDs
Component
Status
Definition
Green (Solid)
On, operating correctly
I/O Module
OK
Green (Blink)
Controller error
Amber
Fault Condition
I/O Module
Fault
Clear
Normal
MediaStore 5100: SAS link activity LEDs
During normal operations, the three SAS connections on an I/O module are measured for Link Activity.
Figure 9-9: MediaStore 5000 series SAS link activity LEDs
Indicator
Status
Green, solid
Ready, no traffic
Green, blink
Active, I/O traffic
Green, blink, all module
indicators
Fault Condition, or rebooting
MediaStore 5000 series I/O module components
Two Input/Output (I/O) Modules are mounted in the rear of the MediaStore. Both modules are the same—
mechanically and electronically.
The
Primary I/O
module is the module installed in the
top
slot. The
Secondary I/O
module is the module
installed in the
bottom
slot.
201
Spectrum System 8.4 Installation Guide
