Chapter 11 DSNG Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved.
314
Ellipse 3000 Release 3.0, Rev. B
IF Modulator Parameters
11.3.3
L-Band Monitor Frequency
The L-Band monitor monitors the modulation outputs.
The L-Band Monitor Frequency parameter displays a read-only value of the L-Band monitor
frequency value. The interface’s parameter values are 1080 MHz at
−
45 dBm.
Front Panel
To view the L-Band Monitor Frequency parameter on the front panel:
❖
Navigate
Root > IF Modulation > L-Band Monitor Frequency
.
Web Manager
To view the L-Band Monitor Frequency parameter in the Web Manager:
❖
Select
DSNG > MODULATOR AND UPCONVERTER
(see Figure 11–3).
11.3.4
Output Impedance
The Output Impedance parameter allows controlling the IF modulator output impedance of the
encoder to coordinate with the impedance of the next stage UCM (up-converter modulator).
The available options are: 50 and 75 Ohm. The Output Impedance default value is
50 Ohm
.
Front Panel
To set the Output Impedance parameter on the front panel:
❖
Navigate
Root > IF Modulation > Output Impedance
.
Web Manager
To set the Output Impedance parameter in the Web Manager:
❖
Select
DSNG > MODULATOR AND UPCONVERTER
(see Figure 11–3).
Output Impedance
‚ 50 ohm
ƒ 75 ohm
