Harmonic Ellipse 3000, User Manual

Page: 307 / 403

Chapter 11 DSNG Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved. 307 Ellipse 3000 Release 3.0, Rev. B
L-Band Modulator Parameters
11.2.5 RF Conv. LO Frequency
The RF Conv. LO Frequency parameter sets the local frequency of the upconverter. According to
the selected value, the Ellipse can identify the use of Ku-Band, C-Band, or L-Band.
Front Panel
To set the RF Conv. LO Frequency parameter on the front panel:
❖
Navigate
Root > L-Band Modulator and Up-Converter > RF Conv. LO Freq
.
The range is 0 to 100,000,000 kHz. The RF Conv. LO Frequency default value is 14,000,000 kHz .
Web Manager
To set the RF Conv. LO Frequency parameter in the Web Manager:
❖
Select
DSNG >
Modulator and Up-Converter
(see Figure 11–2).
11.2.6 L-Band Frequency
The L-Band Frequency parameter sets the L-Band frequency rate. This parameter changes
automatically according to any change in the TX RF Freq (frequency) rate.
The range is 950,000 to 1,750,000 kHz. The L-Band Frequency default value is 1,000,000 kHz.
Front Panel
To set the L-Band Frequency parameter on the front panel:
❖
Navigate
Root > L-Band Modulation and Up-Converter > L-Band Frequency
.
Web Manager
To set the L-Band Frequency parameter in the Web Manager:
❖
Select
DSNG > Modulator and Up-Converter
(see Figure 11–2).
RF Conv. LO Freq
+014000000 [kHz]
<000000000 - +100000000>
L-Band Frequency
+1000000 [kHz]
<+0950000 - +1750000>