Chapter 8 Output Interface Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved.
241
Ellipse 3000 Release 3.0, Rev. B
IP OUT Sub-Menu/Tab
CAUTION:
The IP output parameters manage the IP definitions of the Ellipse unit and the destination IP
definitions. These parameters have default values set in the factory. However, default values may not be
compatible for the user’s network and will not allow the user to work with them.
The user must configure the values before starting to use the IP output interface.
8.1.1
DVBoIP1/2 Sub-Menu/box
Front Panel
To access the DVB over IP sub-menu on the front panel:
❖
Navigate
Root > Configuration > Physical Output > IP OUT > General > DVBoIP1 Menu
.
Web Manager
Use the DVB over IP (DVBoIP1 or DVBoIP2) sub-menu/box to display or configure the following IP
related parameters:
■
Node IP Address
– Sets the encoder IP address. The available value is an IP address
xxx.xxx.xxx.xxx.
■
Node Subnet Mask
– Sets the encoder Subnet Mask address. The available value is an IP
address xxx.xxx.xxx.xxx.
■
Node Default Gateway
– Sets the encoder default gateway address. The available value is an IP
address xxx.xxx.xxx.xxx.
■
Node UDP Port
– Sets the encoder UDP port number. The range is 0 to 65535.