Harmar Mobility AL003, Installation & Service Manual, Page: 27 / 36

Outside Vehicle Lifts: Installation & Service Manual
06DEC19 | P/N: 630-00106 REV A
27
OUTSIDE VEHICLE LIFTS: SECTION 6
LIFT ADJUSTMENTS
Figure 6-23
4. Adjustments may also be done with the driver’s
side wheel chocks for chairs with smaller drive
wheels, or to adjust for better center of gravity.
The platform’s wheel ramps will also need to be
adjusted. Using a #2 Phillips screwdriver, remove
the ramps. See Figure 6-24.
Figure 6-24
5. Once satisfied with the wheel chock positions,
replace the entry ramps. See Figure 6-25.
Start by laying both angled portions of the ramps
on the angles of the wheel chocks and rest on
top of the stationary ramps as indicated. With
the ramps laying on top of the wheel chocks,
find “PEMS” pressed in the stationary ramps.
See Figure 6-26.
Figure 6-26
Find the closest alignment with the multiple holes
of the upper ramps and “PEMS” while the upper
ramp is pressed against the wheel chock angle. See
Figure 6-27.
Figure 6-27
PRESS
PRESS
PEM
PEM
PEM
PEM
Figure 6-25
The wheel chock’s hole is designed to be off center,
allowing 1/2
" increments. Rotate the wheel chock 180
degrees to move the ramp by 1/2 " . See Figure 6-23.
NOTICE
L
L
C
C
+
+
1/2”