Outside Vehicle Lifts:
Installation & Service Manual
06DEC19 | P/N: 630-00106 REV A
22
OUTSIDE VEHICLE LIFTS:
SECTION 6
LIFT ADJUSTMENTS
4.
Adjust the top nut, so the top of the nut
measures 21/4
"
to 2 1/2
"
above the top of the
hold-down arm. Once the measurement has
been set, DO NOT adjust the top nut or the
stationary nut. See Figure 6-4.
If the hold-down foot is set too loose, the foot
may not have enough pressure to hold the
scooter down. If too tight, the foot may cause
damage to the scooter and/or lift.
CAUTION
!
Figure 6-4
5.
Lower the platform about 5
"
to relieve pressure
from the scooter’s deck. While holding the
stationary nut in place, run the bottom nut up to
the hold-down arm and tighten. See Figure 6-5.
Figure 6-5
Do not rotate the stationary nut; otherwise, it
will change the pressure that was previously set.
CAUTION
!
AL100, AL160 & AL300
WHEEL CRADLE ADJUSTMENTS
Add or replace a rear wheel cradle on an outside
vehicle lift. Always adjust for tire size.
Assemble components as indicated below.
See Figure 6-6.
Figure 6-6
Test by positioning scooter onto platform.
Top of the Nut
2 1/4
"
to 2 1/2
"
Top of
Hold-Down Arm
Tighten
Hold in Place Tight
IF APPLICABL
E
IF AP
PLICA
BLE
2
2
4
6
5
2
7
6
8
2
Summary of Contents for AL003
