Martin VDO Atomic Bold user guide
33
Maintenance
Read Safety information on page 6 before maintaining the fixture. Always
comply with the safety instructions.
Refer any service operation not described in this user manual to a qualified
service technician.
Excessive dust, smoke fluid, and particle buildup degrades performance, causes
overheating and will damage the fixture. Damage caused by inadequate
cleaning or maintenance is not covered by the product warranty.
Disconnect mains power before cleaning or servicing the fixture.
Fixtures must be serviced in an area where there is no risk of anyone being
injured by failing parts, tools or other materials.
Installing optical accessories
Installing one of the optical accessories available from Martin® for the VDO Atomic Bold takes a
few seconds. No tools are required.
1
2
To install an optical accessory:
1. Slide and lift up the hinged retaining clip (1) on the top of the VDO Atomic Bold and hold it
back.
2. Slide the optical accessory into the PAR64-sized holders (2) on the front of the fixture,
ensuring that the accessory is correctly located on all sides.
3. Gently release the retaining clip and ensure it locks the accessory in position.
When using the Martin VDO Atomic Bold Diffuser, make sure that you insert it with the matt side
towards the fixture.
Cleaning
Cleaning schedules vary depending on the operating environment. It is therefore impossible to
specify precise cleaning intervals for the VDO Atomic Bold. Environmental factors that may result
in a need for frequent cleaning include airborne dust and pollution.
Summary of Contents for Martin VDO Atomic Bold
Page 1: ...VDO Atomic Bold User Guide...
