Fixture setup
19
DMX Address
To set the DMX address using MUM, click on the
Fixture settings
button and use the
DMX Address
spin
buttons to set the fixture’s DMX address. The DMX address will be updated in the fixture in real time.
DMX Mode
The
DMX Mode
setting allows you to set the fixture to respond in various control modes.
To set the DMX mode using MUM, click on the
Fixture settings
button and use the
DMX Mode
drop-down
dialog box to select the desired mode. The DMX mode will be updated in the fixture in real time.
Bear in mind that changing the DMX mode may affect the number of DMX channels the fixture uses.
The following modes are available:
Exterior 400, Exterior 410
•
RAW
(Individual control of red, green, blue and white LED groups - uncalibrated)
•
RGB
(red, green, blue - calibrated, all LEDs including white can be activated to optimize color and
intensity)
•
HSI
(hue, saturation, intensity - calibrated)
•
HSIC
(hue, saturation, intensity, color temperature - calibrated)
Exterior 420
•
RAW
(Individual control of warm white and cold white LED groups - uncalibrated)
•
CT
(intensity, color temperature - calibrated)
Exterior 430
In Exterior 430 red, green and blue single-color fixtures, RGB & HSI modes let you fine-tune the fixture’s
main color by adding a little of the other two primary colors.
•
RGB
(red, green, blue - calibrated if
Color Gamut
set to
Exterior 400 Range
, uncalibrated if
Color
Gamut
set to
Fixture
)
•
HSI
(hue, saturation, intensity - calibrated if
Color Gamut
set to
Exterior 400 Range
, uncalibrated if
Color Gamut
set to
Fixture
)
•
I
(intensity - calibrated)
Figure 16: Fixture settings window
