Harman Martin ERA 150 Wash, User Manual

Page: 22 / 52

22 Martin ® ERA 150 Wash User Guide
2. Using the DOWN and UP buttons, select BLACKOUT or HOLD to
decide how the fixture should respond if it stops receiving a DMX signal:
-
If you select BLACKOUT, the fixture will black out
-
If you select HOLD, the fixture will continue to show the effect that it
is displaying at the time.
3. Press ENTER to confirm your choice (or press MENU to exit without
making a change).
Cooling mode
The cooling mode setting lets you decide whether to give priority to lowest
cooling fan noise or maximum light output:
1. Select COOLING MODE and press ENTER. The currently set mode will
blink in the display.
2. Using the DOWN and UP buttons, select one of the three cooling
options:
-
If you select REGULATED FANS, the fans operate at normal speed.
Temperature regulation increases fan speed if the fixture
approaches its maximum operating temperature. This setting
provides a good compromise between low fan noise and powerful
light output.
-
If you select THEATER MODE, the fans operate at lower speed.
Temperature regulation reduces maximum light output if the fixture
approaches its maximum operating temperature. This setting gives
priority to the lowest possible noise.
The THEATER MODE setting also increases the LED PWM
frequency to 19 200 Hz to ensure flicker-free high speed video
recording.
-
If you select FULL, the fans operate at full speed without
temperature regulation. This setting maximizes cooling and gives
priority to the highest possible light output intensity.
3. Press ENTER to confirm your choice (or press MENU to exit without
making a change).
Display rotation
To set the orientation of the control panel display:
1. Select DISPLAY → DISPLAY ROTATION and press ENTER.
2. Use the DOWN and UP buttons to select NORMAL (display in normal
orientation) or ROTATE 180° (display inverted to make it easier to read if
you install the fixture hanging vertically from its mounting bracket).