QUICK START GUIDE
TTS Secure Surface Mounting / Alternate Cable Routing
Overview
Each of the TTS Table-Top Stands features a Cable Knockout and three mounting holes
on the bottom panel that allow you to provide a secure surface-mount installation.
When surface mounting the TTS, all cabling will enter the TTS enclosure through the
knockout on the bottom panel, using strain relief inside the enclosure (FIG. 1).
Note that in this type of installation, the rear panel connectors on the TTS are not used,
since the cables entering the enclosure through the bottom panel connect directly to
the Touch Panel, Keypad(s) or ControlPad installed in the Table-Top Stand.
Strain Relief Accessories
Included with each TTS Table-Top Stand is a cable Strain Relief and Strain Relief Bracket
that mount inside the TTS enclosure:
Cable Strain Relief (45-0004-04)
The Cable Strain Relief (FIG. 2) mounts onto the cable.
Strain Relief Bracket (62-1800-06)
The Strain Relief Bracket (FIG. 3) mounts to the bottom panel of the TTS enclosure,
using the center mounting hole.
Note that the screw that secures the Strain Relief Bracket also serves as one of three
mounting screws that secure the TTS enclosure to the mounting surface.
Preparing the Mounting Surface
1.
Establish the desired location and position for the installation.
Refer to FIG. 4 and FIG. 5 for the dimensions of the bottom panel and the location
of the three mounting holes.
The mounting holes are 0.166” (4.22 mm). See “Mounting Specifications” for
details.
2.
Drill three mounting holes into the surface.
Mounting Specifications
The following illustrations provide detailed dimensions of the bottom panel of the TTS
Enclosures.
NXA-TTS43X-BL and NXA-TTS500-BL
The NXA-TTS43X-BL and NXA-TTS500-BL share the same TTS enclosure (FIG. 4):
MET-TTS1/2/3-BL and AP-TTS16-BL
The MET-TTS1/2/3-BL and AP-TTS16-BL share the same TTS enclosure (FIG. 5):
FIG. 1
CABLE KNOCKOUT, STRAIN RELIEF AND SURFACE MOUNTING HOLES ON TTS ENCLOSURES
FIG. 2
CABLE STRAIN RELIEF (45-0004-04)
FIG. 3
STRAIN RELIEF BRACKET (62-1800-06)
Cable Strain Relief
Cable Strain Relief Bracket
Cable Knockout
(shown with knockout removed)
Surface Mounting Holes
Mounting screw passes
through the Bracket to
secure the TTS enclosure
to the mounting surface
(see Fig. 1)
Cable with Cable Strain
Relief mounts here
FIG. 4
BOTTOM PANEL SPECIFICATIONS - NXA-TTS43X-BL AND NXA-TTS500-BL
FIG. 5
BOTTOM PANEL SPECIFICATIONS - MET-TTS123-BL AND AP-TTS16-BL