commissioning
DMS800 MANUAL
77
6
Commissioning
Before commissioning your DMS800, check that the transmitter and receiver
are set to the same frequency.
To commission the DMS800, proceed as follows:
1.
Insert batteries into the transmitter
2.
Connect the antennas
3.
Position the receiver
4.
Connect the receiver to the mixing console/amplifier
5.
Reposition the GROUND LIFT switch (optional)
6.
Connect the receiver to the power network
6.1
Insert batteries into the transmitter
Step Description
1
Open the battery compartment cover (9)
2
Insert batteries into the battery compartment.
When inserting the batteries, note the symbols in the battery
compartment to ensure the power supply.
3
Close the battery compartment cover (9)
6.2
Connecting the antennas
The following antennas can be mounted on the receiver:
•
λ/4 antennas
(included as standard)
For all applications where there is a line of sight between the trans‑
mitter and receiver antennas.
•
Remote antennas
For applications where the reception conditions are not optimal at
the receiver position.
