9
Installation
IMPORTANT NOTE:
The Accentra unit is shipped
bolted to the skid through two holes in the cast base
plate. If these holes are not used to lag the unit to
the floor these holes must be filled with the 3/8" x 1/
2" hex head bolts provided. (See tag on bolt bag
provided.)
Leveling/vibration-dampening feet
Skid bolt down holes/floor lag down holes
Fig. 14
Fig. 15
Adjustment of the rubber pad leveling feet
The Accentra is provided with 4 rubber pad feet.
These feet will raise the bottom edge of the cast
base plate off the floor surface. This will insure that
any vibrations caused by motors and other moving
parts will not be transferred by direct contact. These
rubber pads have a threaded stud that extends
through the base plate. The top of the threaded stud
has a screwdriver slot. Therefore, the unit can be
leveled from above inside the unit. The front two are
in the right and left front corners of the firebox.
NOTE: The door will need to be partially closed to
access the right leveling pad stud due to the door
hinge.
The rear two studs are to the right and left of
the distribution blower. They are somewhat difficult
to reach, therefore, it is suggested that the rear two
pads be adjusted by tilting the unit slightly forward.
Adjust the pads with your fingers and tilt unit back
for fit. Then adjust the front pads for the final
clearance. (The use of the rubber pads is not
necessary if not desired.)
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.
Summary of Contents for Accentra 2
Page 26: ...26 Accentra Wiring Diagram...
