Rev.0
–
19/03/2021
27
10.2 Internal maintenance procedure
10.2.1 Maintenance product
The maintenance products listed below must be used:
Strong threadlocker
– Green (i.e. LOCTITE
®
270)
Clean the parts and apply the product, spreading it all over the
thread as shown.
Assemble the parts and wait at least 45 minutes before use. To
remove screws sealed with threadlocker, you may need to heat
the parts to reduce the effect.
WARNING!
Do not apply this product to screws driven into
carbon components.
Medium threadlocker
– Blue (i.e. LOCTITE
®
243)
Clean the parts and apply the product, spreading it all over the
thread as shown.
Assemble the parts and wait at least 45 minutes before use.
Generally, for use on all screws, requires no heating before
removal.
Synthetic GREASE Harken - BK4513
Apply a film of grease with a brush to all the parts indicated, and
make sure that the film is visible. Take special care when
greasing the teeth of the ring gears, the gears and the roller
bearings.
It is important to keep the teeth of the ring gears of our products
greased to increase their efficiency and life.
WARNING!
Parts, and especially the gears of the tensioner that
are not sufficiently greased will undergo irreversible
wear that is not covered by the warranty.
Summary of Contents for Tensioner CT0
