Installation and service must be provided by a qualified installer,
service agency or the gas supplier.
ADEQUATE FIREPLACE VENTILATION IS REQUIRED FOR SAFETY
READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING
INSTALLER: LEAVE THESE INSTRUCTIONS WITH CONSUMER!
NOTE:
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do
not use the phone in your building.
3. Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
4. If you cannot reach your gas
supplier, call the fire department.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
It is the homeowner’s responsibility to assure
their fireplace has adequate draft
RECOMMENDED BURN –IN PERIOD
Hargrove gas logs are made of special
refractory materials, which withstand high
temperatures. One characteristic of this
material is retention of moisture. For this
reason, we recommend burning the logs for
only fifteen minutes during the first burning.
After allowing the logs to cool for at least one
hour, the set can be burned for any length of
time.
WARRANTY
Hargrove gas logs carry a limited lifetime
warranty against breakage in the original
fireplace. Warranty does not include labor.
This warranty is void if excessive handling
after burning causes breakage. All
accessories and metal parts carry a two year
limited warranty in the original fireplace.
Hargrove will replace items during this period
for the cost of shipping.
INSTALLATION AND OPERATION GUIDE FOR
HARGROVE
GAS LOGS
For all models tested through OMNI-Test Laboratories, Inc., to
ANSI Z21.60-2003/CGA 2.26-2003, Decorative Appliance for Installation in Solid-Fuel Burning
Fireplaces.
For model number and seal refer to attached nameplate.
Hargrove Manufacturing Corporation uses refractory material to create ceramic logs. Each log is
hand-finished to assure the most realistic, detailed log available. The gas log burner system is
designed to burn like wood, with a smoky flame. For this reason, the gas log set must be burned only
in a fully vented, non-combustible fireplace with the
damper completely open
and the chimney free
of any obstructions or restrictions. The fireplace must be designed and approved to burn wood.
The realistic yellow flame produces carbon monoxide and soot. Under normal conditions, these
products are exhausted up the chimney. If fumes or soot, from the gas burning, are evident in the
room when the damper is fully open it indicates that the fireplace draft is defective. Do not operate
your gas log set until the fireplace draft is corrected.
