Hardy Floor Scales
19
Installing the
Leveling Feet
Step 1.
Remove the lock bolt and nut from the lev-
eling foot.
Step 2.
With the scale raised and securely
blocked, insert the leveling foot into the
load sensor. Make sure the through hole in
the foot is aligned with the bottom through
hole on the load sensor. (See Fig. 14)
FIG. 14 INSERTING THE LEVELING FOOT
INTO THE LOAD SENSOR
NOTE:
You may need to push with a little force due to some
interference caused by the O-ring that is attached to
the foot. DO NOT USE A HAMMER OR TRY TO
DRIVE THE FOOT INTO THE HOUSING.
Step 3.
With the through holes aligned, insert the
lock bolt going from the center of the scale
outward. This eliminates having to remove
Summary of Contents for HIFS-3030-01-PS-T
