Hardy Process Solutions HI 2160RC PLUS, Operation And Installation Manual

Page: 57 / 220

HI 2160RC
PLUS
MANUAL
4-8
Setting the Jumpers
Setting the Jumpers
in the HI
2160RC
PLUS
Step 1. Get the analog signal information from the analog output
device documentation.
Step 2. Disconnect the power cord.
Step 3. Use a phillips screw driver and remove the two (2) pan head
machine screws that fasten the rear panel to the extrusion.
(See Fig. 4-3)
Step 4. Gently pull out the rear panel with the top and bottom panel
and printed circuit boards attached.
Step 5. Remove the two (2) pan head machine screws that attach the
top panel to the rear panel. (See Fig. 4-4)
Step 6. f.Set the jumper that matches the system's feedback voltage or
current configuration. Select one only. (See Fig. 4-8) (See
Tables 4-3, 4-4, 4-5)
Step 7. Attach the top panel to the rear panel by replacing the two (2)
pan head screws.
Step 8. Gently slide the rear panel back into the extrusion.
Step 9. Replace the pan head machine screws that attach the rear
panel to the extrusion.
TABLE 4-3: INPUT SELECTION
FUNTION DESCRIPTION JUMPER
INPUT TYPE
SELECT
0 - 5 VDC W1
0 - 10 VDC W2
CURRENT W3
TABLE 4-4: CURRENT RANGE SELECTION
INPUT RANGE SELECT
4-20 mA Range W5
0-20 mA or 0-5, 0-10 VDC W8
TABLE 4-5: CURRENT SENSE SELECTION
CURRENT SENSE
SINGLE UNIT CURRENT SENSE W6
MULTI UNIT CURRENT SENSE, MID UNIT CURRENT LOOP.
LAST UNIT HAS W6 INSTALLED W7
Setting the Jumpers
in the Optional
Quad Expander Box
Step 1. Get the analog signal information from the analog output
device documentation.
Step 2. Disconnect the power cord.