Hardy Process Solutions HI 2160RC PLUS, Operation And Installation Manual

Page: 120 / 220

Chapter 6 - Setup
6-29
• A correction factor is often not necessary but if needed must be
determined by trial and error. A negative value (percentage of up to
-10%) will decrease the flow rate, and a positive value (percentage
up to +
10%) will increase the flow rate.
• Setting the Refill Correction Factor to decrease to decrease flow
rate:
Step 1. Press the down arrow
↓
until the cursor is next to RFL
CORR. (See Fig. 6-22) The percentage range is -10% to
+10%.
Step 2. Press the -/Clear button one time for negative sign to
appear before the percentage value. Press the -Clear but-
ton two times for a positive sign to appear before the per-
centage value.
Step 3. Use the numeric keys to enter the percentage value.
NOTE: Disregard the decimal point. An entry of .1 is 1%, 1.0 IS 10% AND SO ON.
Step 4. Press the Enter button to accept the value.
AUTO REFILL MENU
HI SHUTOFF 2.000
INITIAL F ILL YES
RFL CORR. 0. 0
FIG. 6-22 AUTO REFILL MENU/SETTING THE REFILL CORRECTION
FACTOR
Force Refill
• This function allows the user to refill the feeder hopper to the
“STOP (HI)” level at any time.
• To force a refill, momentarily short the Remote Functions REfill
Pin to ground. (See Fig. 6-23)
• During the refill a **FORCE REFILL** message appears on the
display and returns to the previous display when the refill is com-
plete.