Assembly and installation
Attention:
The
assembly, installation and initial commissioning
of the charging
station must be exclusively by qualified
Specialized personnel take place
.
The cPP2 charging pole is an electrotechnical device and is therefore subject to certain
specifications for indoor and outdoor installation. Although the housing of the cPP2
complies with the regulations described for protection class IP44, you must take the
following environmental conditions into account in particular:
•
For safe operation of your charging station, minimum distances to other technical
installations must be taken into account: For more information, please contact
your electrical installation company or your sales partner.
•
The charging station must be mounted so that it is freely accessible to persons
authorized to operate it.
•
Select the mounting location so that you can easily reach the charging socket on
the vehicle with the optionally available charging cable of the cPP2: The cable
must
NEVER
be under tension when connected to the vehicle.
Requirements for the assembly site
The cPP2 charging pole was developed for indoor and outdoor use. For proper charging,
you as the operator must observe the following specifications for the location and
installation.
•
Consider all local regulations for electrical installations, for fire prevention as well as
for accident prevention.
•
All specifications for the installation of low-voltage systems according to
DIN VDE 0100.
•
The mounting surface must have sufficient strength to withstand the mechanical
loads and thus must not be installed directly on the asphalt or a concrete floor. A
concrete foundation with suitable specifications must be used. We offer a suitable
concrete foundation for this purpose (see S16).
•
The soil at the mounting location must allow drainage of any liquids that enter the
pedestal.
Installation and operating manual
cPP2
charging pole
Version: 1.0.2
17