Installation Instructions for WPO2 Series
“No Wiggle” Wall Pullout Organizer
Important:
Before you begin, make sure you familiarize yourself with all
of the parts and fully read the instructions.
Customer Service:
A toll-free customer help line is available weekdays between
7:00 am and 6:00 pm Central Time at 800-463-0660.
Tools Needed: __
Screw gun or Phillips screwdriver and tape measure.
NOTE: If screw gun has a clutch, set to lowest setting so as to not
over tighten and/or strip screws.
Parts Identification:
Step 1: Prepare Organizer for Installation
Remove the Organizer from Slide Base by releasing the
four (4) pre-installed screws. Keep these screws in a safe
place for later use.
Step 2: Slide Base Installation
Install the slide base from the inside of the wall cabinet’s
base panel with the #10 wood screws.
After installation, pull out the slide base upper portion to
test and ensure smooth operation.
To watch the WPO2 installation
video, scan the QR code or visit
the link below:
https://delivr.com/2zu57
A
(1 pc.)
“No Wiggle”
Wall Pullout
Organizer Unit
B
(1 pc.)
Base Runner
Mechanism
C
(1 pc.)
Rear Support
Bracket
D
(4 pcs.)
#1/4-20 Truss
Head Machine
Screws
E
(4 pcs.)
#1/4 Washer
F
(4 pcs.)
#10 x 1/2 Pan
Head Phillips
Wood Screw
G
(5 pcs.)
#8 x 5/8” Flat
Head Phillips
Wood Screw
H
(3 pcs.)
#8 x 5/8” Pan
Head Phillips
Wood Screw
A
F
B
E
D
H
C
G
