STEP 1
Disassemble both the top and bottom mounting slides as
illustrated above.
STEP 2 - Top Installation
15”
2-3/8”
30”
15”
15”
Using the tape measure and square layout and install top
mounting slide according to the dimensions shown above
using three (3)-#8 x 5/8” flat head Philips wood screws
provided.
IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
CUSTOMER SERVICE:
Toll free customer help line available weekdays between 7:00am
and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun, Phillips screwdriver, tape measure, and square. You
will also need an 8mm and 13mm open end wrench to fully
assemble this unit. NOTE: If screw gun has a clutch, set to lowest
setting so as not to over tighten and/or strip screws.
A
Shelves
RSR-12:12 pcs
RSR-08: 8 pcs
RSR-04: 4 pcs
B
Top Slide
1 pcs
C
Bottom Slide
1 pcs
D
Control Arm
2 pcs
E
Plastic Corner Connectors - Includeds #4 x 5/6
Washer Head Phillips Machine Screws
4 pcs
F
Bearing Pin
2 pcs
G
Connecting Pin
2 pcs
H
Frame Crossbar
2 pcs
I
Frame Upright
2 pcs
J
8 mm Nut
4 pcs
K
Metal Washer
4 pcs
L
13 mm Cap Nut
2 pcs
M
#4 x 5/16 Washer Head Phillips Machine Screw RSR-12: 48 pcs
RSR-08: 32 pcs
RSR-04: 16 pcs
N
1/2” Silicone Washer
4 pcs
O
1-3/8” Silicone Washer
2 pcs
P
#8 x 5/8 Flat Head Phillips Wood Screw
7 pcs
DIMENSIONS:
Cabinet minimum opening: 30” wide x 15” deep x
12 Shelves
8 Shelves
4 Shelves
72” high
50” high
27-1/2”” high
PARTS IDENTIFICATION:
Rotating Shoe Rack
Installation Instructions
for the RSR Series
