Face frame
Front plywood
runner
Bottom Measurements
Rear Bracket Measurements
NOTE: Illustrations for measurement only. Installation of brackets and mounts will begin in Step 3
14-1/2”
A
B
2”
A
14-1/2”
1”
2”
2”
B
1-3/16”
11/32”
15/16”
1-3/4”
1-5/32”
STEP 1 - Determine Mounting Location
Place the entire unit into the cabinet. In framed cabinets, center the unit in the opening making sure the front plywood runner is
pulled tight against the back of the face frame. For frameless cabinets, place the unit within 1-1/2” of the left of the cabinet and the
front plywood runner needs to be set back 3/4”. The top of the unit should be flush with the face frame. If the unit is sticking out or is
setback by more than 1/4”, place a shim under either the front or the back plywood runner to make it flush.
IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
CUSTOMER SERVICE:
Toll-free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver and tape measure. NOTE: If
screw gun has a clutch, set to lowest setting so as not to over
tighten and/or strip screws.
PARTS IDENTIFICATION:
A
Mounting Base
1 pcs
B
Base Pullout Unit
1 pcs
C
#10 x 3/4” Pan Head Wood Screw
4 pcs
D
#8 x 5/8” Pan Head Wood Screw
4 pcs
E
#8 x 5/8” Flat Head Wood Screw
4 pcs
Base Pullout
Installation Instructions
for the BPO2 Series
Part #
A
B
BPO2-5
2-9/16” 2-27/32”
BPO2-8
2-17/32”
1-1/4”
BPO2-11 4-23/32”
2-3/8”
BPO2-14 7-23/32”
3-7/8”
C
A
B
D
E
Front plywood runner
Flush with face frame
BPO2-5
BPO2-8
• BPO2-11 • BPO2-14
