Page 14 of 22
CUS-013-0028-09
Controller Functions
This section contains information for basic operation and programming of the Inferno 4500 system.
4.6.1
Notifications and Alarms
(Press STOP
once to end a buzzer. Press and hold STOP
for 3 seconds to stop any action except
an AUTO CLEAN cycle.)
At the end of a preheat cycle when the correct temperature is reached, a buzzer sounds for 5
seconds and the yellow end of program light turns on (Figure 3-1 on page 6, Figure 3-2 on page 7).
If the rotisserie temperature then drops below 150 ˚F [65.6 ˚C], the red alarm lamp will flash and a
message on the controller display will prompt to repeat the preheat cycle.
At the end of a cooking cycle and of subsequent cook time additions, a buzzer sounds for 10 seconds
and the yellow end of program lamp turns on.
In case of a
Safety Lock Out
(gas burner does not light), the red SLO (Safety Lockout) alarm lamp will
flash continuously (shown in Figure 3-3 on page 8).
4.6.2
Programming
The controls allow many of the rotisserie’s parameters to be accessed and modified. Only the basic
programming of “Favorites” is described in this manual. Additional modification of the parameters must be
performed by an authorized service technician. Please call Hardt Customer Service for further information.
Use PROGRAM UP / PROGRAM DOWN
,
to scroll through menus and to change settings,
press ENTER
to select (and then again to validate selection) and STOP
to exit.
4.6.3
Programming Favorites
A Favorite is a shortcut to a cooking program. To assign a different cooking program to a Favorite button:
1. Hold EDIT
and a single FAVORITE
key simultaneously for three seconds.
(Display shows
“P0 / 7-8 SKS MANUAL”).
2. Use the PROGRAM UP
or PROGRAM DOWN
buttons to locate any program in memory from
1 to 16.
3. Press ENTER
to save program selection to that Favorite button.
