Hardi RANGER EAGLE, Original Instruction Book

Page: 35 / 100

4 - Sprayer setup
35
Power supply
Power requirement is 12V DC. Always note polarity! For proper function
of the electric equipment, the wires must have the following
recommended cross sectional areas and correct fuses to ensure a
sufficient power supply. The delivered power connectors follows the
standard of most newer tractors. If you have a tractor with another
power connector, it is necessary to disassemble the connector and fit it
to the actual tractor connector.
The number and the type of connectors may vary on the specific
sprayer, depending on its equipment.
Speed transducer for sprayer
The speed transducer and speed ring are located at the inside of the
sprayers right wheel. The sensor is an inductive type that requires a
metallic protrusion like a speed ring to pass by it to trigger a signal.
Adjustment
1.
Assure that the speed ring is correctly fitted to the wheel, so that
the arrow (A) follows the forward rotation of the wheel.
μ
Adjust so the sensor lines up in the middle of the gaps in vertical
direction.ATTENTION! If necessary readjust plate on the axle.
2.
Adjust air gap (B) to 3.0 +/-0.2 mm. Use 3.0 mm feeler gauge or
similar tool.
÷
NOTE! Adjustment shall be made out of one of the carriage bolts for the speed ring.
3.
After adjustment then spin up the wheel. Verify air gap variation less than +/-0.5 mm. Check this at the entire
circumference.
4.
Verify Speed at the controller.
μ
ATTENTION! Correct fitting is indicated by continuous flashing from transducer when the wheel rotates.
Road safety kit
Connect the plug for rear lights to the tractor’s 7-pin socket, and check the function of rear lights, stop lights, side lights and
direction indicators on both sides before driving.
The wiring is in accordance with ISO 1724. See section in “Technical specifications”.
μ
ATTENTION! Turn OFF all work lights when driving on public roads!
CIGAR CONNECTOR
Spray control unit requires:
Wire 2.5 mm
2
, Fuse 10 Amp
Hydraulic control unit requires:
Wire 4.0 mm
2
, Fuse 16 Amp
7 POLE TRAFFIC LIGHT CONNECTOR