Hardi Mercury Covamax series, Operator'S Instruction Manual, Page: 43 / 110

4 - Set Up
4. 3
Connecting Mistblower to tractor
Connecting the mistblower requires the following;
• Adjusting drawbar length
• Hitching drawbar to tractor
• Connecting hydraulics to tractor
• Sizing & Fitting PTO shaft
• Un-mounting Jockey Wheel
• Connecting control box (if fitted)
Adjusting drawbar length
Both drawbar designs have the ability to be adjusted. The basic steps to follow are;
• Support mistblower on jockey wheel
• Loosen bolts (C) where the drawbar passes through the
chassis
• Remove nut & bolt (B)
• Slide drawbar in or out of the frame to desired position
• Refit nuts & bolts (B) and tighten lockbolts (C) sufficiently to
prevent movement
Additional adjustments can be made by altering hole positions of plates (A) on wide angle drawbar
μ
Attention: Make sure the bolt passes through both the holes in the frame and the holes in the drawbar as shown (B)
and that locknuts (C) are securely tightened.
B
C
A