Hardi AutoHeight, Instruction Book

Page: 37 / 62

37
5 - Operation
System operation
General info
This section outlines the AutoHeight system's features and controls during field operation. Before you can operate your
AutoHeight system in AUTO mode, it needs to be configured either automatically or manually. If your control panel shows
the power up sequence below and will allow AUTO mode, it has been configured. If your panel shows different messages
after being powered up or will not allow AUTO mode, it will attempt to begin or resume Automatic System Setup. Refer to
“System preparation” on page 23 for System Setup instructions.
Power Up Sequence
Upon power-up a sequence of messages are temporarily displayed on the control panel LCD screen. The system will always
power up in manual mode. The system is ready for use once the run screen is displayed.
÷
NOTE! To access either the "SENSOR DISPLAY" or "SETUP" menus, ensure you are at the run screen.
Table 9 - Power Up Screens
LCD Display Description
UC4 +
AutoHeight Panel.
V. 7A
Version 7A software.
Type HD4
Sprayer Type: HD4. See “Sprayer types” on page 57 for a list of types.
METRIC
The panel is set up to display height in centimeters. This can be changed to display inches.
* Roll
The control panel is looking for connected sensors.
3 Height
Three height sensors are connected.
Allocate
The control panel is preparing to set up each sensor.
Setup LO
The control panel is setting up the Left outer (
LO
) sensor, followed by the other sensors (
LI
,
RO
,
RI
,
MR
,
ML
).
Ready
The control panel is ready to begin operation.
M 75 M
The run screen. This screen is shown until input is received from the operator. (“To access either the "SENSOR DISPLAY" or
"SETUP" menus, ensure you are at the run screen.” on page 38)