Page 7
For technical questions, please call 1-888-866-5797.
Item 66784
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
Setup - Before use:
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Disconnect the pump from its power supply before assembly/installation.
note:
For additional information regarding the parts listed in the
following pages, refer to
Parts List and Diagram
on page 10.
assembly
note:
Thread seal tape mentioned hereafter
is not supplied with this pump.
1. Cut the supplied hose, into two lengths, keeping
in mind that the suction end should be long
enough to reach within one inch of the supply
tank bottom and at the same time to be long
enough so that the Pump could be located at
a point away from the supply tank opening.
nOZZLe (12)
HOSe
cOnnectOr (8)
HOSe
cLaMp (10)
HOSe
cLaMp (10)
HOSe
cOnnectOr (11)
HOSe (27)
puMp
OutLet
2. Apply pipe thread seal tape to the threads
of one 3/4″ Hose Connector (8) and
screw it firmly into the Pump outlet.
3. Apply pipe thread seal tape to the threads
of the 1″ Hose Connector (11) and
screw it firmly into the Nozzle (12).
note:
The included Hose (27) can be cut to
provide an inlet and outlet hose, or another hose
of the same size can be purchased as needed.
any hose used with this product must be
designed for use with the liquid being pumped.
4. Slide two Hose Clamps (10) onto the discharge
Hose (27). Twist each end of the hose over
the two barbed fittings and push forward
until the hose ends presses firmly over the
O-rings and against the fitting shoulder.
5. Slide the Hose Clamps to within 3/8″ of
the fitting shoulder and tighten the screws,
securing the hose onto the fittings.
6. Apply pipe thread seal tape to the threads
of one 3/4″ Hose Connector (8) and
screw it firmly into the Pump inlet.
3/4″ HOSE
cOnnectOr (11)
HOSe (27)
Strainer (33)
HOSe
cLaMp (10)
HOSe
cLaMp (10)
puMp
inLet
7. Slide two Hose Clamps (10) onto the inlet Hose
(27). Twist one end of the hose over the pump
inlet barbed fitting and the other end over the
barbed fitting on the strainer. Push the hose
forward until the hose ends presses firmly over
the O-rings and against the fitting shoulders.
8. Slide the Hose Clamps to within 3/8″ of
the fitting shoulder and tighten the screws,
securing the hose onto the fittings.