Page 8
For technical questions, please call 1-888-866-5797.
60723
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
BEFORE EACH USE,
inspect the general
condition of the Workbench. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2.
AFTER USE,
wipe external surfaces with clean cloth.
Replacing Light Bulb
The Light Fixture has a semitransparent
cover over the bulb.
1. Allow Bulb to cool completely, then gently pull straight
down at both ends of the cover and set aside.
2. Remove the Bulb by rotating it 90º, rolling
in a forward or backward direction and
dropping the Bulb straight down.
3. With the prongs on either end of the Bulb
vertically aligned, fit the new bulb up into the
slots at the right and left fixture receptacles.
4. Rotate the Bulb 90º again to seat
the bulb. Replace the cover.
