12
BLADE INSTALLATION (Continued)
2.
Position the blade (I) over the blade holder arm
(H) with threaded posts showing. Make sure
the bottom edge of the blade (I) is fully seated
against the blade holder arm (H). Tighten
washer-head screws (BB) with fiber washers
(CC) to secure the blade (I) to the blade holder
arm (H). (Fig. 2)
2
Hardware Used
BB
Washer-Head
Screws
CC
Fiber
Washers
BB
CC
H
I
x 15
x 15
NOTE:
Periodically check blade holder hardware
and resecure if necessary.
WARNING
To reduce the risk of personal injury, do
not bend the blade holders when install-
ing, balancing the blades or cleaning the
fan. Do not insert foreign objects in
between the rotating blades.
3. Attach blade holder arms (H) to the hub of
motor assembly (A) using
screws (AA). (Fig. 3)
3
AA
A
H
Hardware Used
x 10
AA
Screws
1.
Remove one of the three screws in the support
bracket of the motor assembly (A). Slightly
loosen the remaining two screws. Assemble
the light fitter assembly (B) to the housing
support bracket of motor assembly (A) using
the two key slots in the light fitter assembly
(B). Replace the third screw and secure all
three screws. (Fig. 1)
LIGHT FITTER ASSEMBLY INSTALLATION
A
B
1
