19
Lowes.com/harborbreeze
BLADE BALANCING INSTRUCTIONS
1. Interchanging positions of adjacent blades (K)
can redistribute the weight and result in smoother
operation. If wobble decreases, leave the blades (K)
as they are. If wobble increases, switch back to the
original position. Attach the balancing clip from the
balance kit (DD) to the mid-point on the top edge of
one blade (K).
WARNING
: The balancing clip must always be fi rmly
pushed onto the blade until it touches the edge of the
blade. Failure to do so could allow the clip to fl y off and
cause personal injury.
1
DD
K
2. Run the fan at high speed (air downfl ow) and observe
wobble. Repeat steps 1 and 2 for each blade (K).
Note which blade (K) has the least wobble. On that
blade (K), install the balancing clip (DD) to the top
edge of the blade (K) near the motor (A). Start the
fan and observe wobble. Stop the fan and move the
balancing clip (DD) in small steps toward the end of
the blade (K). At each incremental step, turn on the
fan and observe the wobble. Determine the location
of the balancing clip (DD) that gives the least amount
of wobble.
2
DD
K
A
3. Peel the backing paper from one of the weighted
squares in the balance kit (DD). Secure the weighted
square in the balance kit (DD) fi rmly to the top of the
blade (M), centered at the balancing clip location
and between the edges of the blade (M). Remove
the balancing clip, start the fan and observe. If the
wobble still persists, repeat steps 1 through 3 with
the remaining weighted squares until the wobble
disappears.
3
DD
K
